Skip to main content
Selora Homes Selora Homes
Shelly
Shelly

Qubino Wave Pro 2PM

DIN-rail 2-channel Z-Wave 800 relay with per-channel power and energy metering, controlling two independent loads up to 16 A each (25 A total). Mains-powered for breaker-box installs, it repeats the Z-Wave mesh to extend range and reliability.

Local over Z-Wave (Z-Wave JS), no cloud; requires a Z-Wave gateway. Two metered relay channels with independent on/off control and per-channel power measurement, DIN-rail mount, overheating/overpower/overvoltage protection; mains-powered so it repeats the Z-Wave mesh.
Works on integrations
Z-Wave
Protocols
Z-Wave
Roles it can fill
Relay Energy Monitor

Recipes using this device

Energy · v1.0.0

High Energy Usage Alert

Installs a Home Assistant automation that watches your whole-home power draw and warns you when it stays high for longer than it should, so a heater or a forgotten appliance does not run all day unnoticed. Add speakers to hear it, add a smart plug to shed the load.

Safety · v1.0.0

Leak Auto Shutoff

Installs a Home Assistant automation that closes your water shutoff valve the instant a leak sensor goes wet, so a burst hose or a failed valve stops flooding within seconds. Add a smart plug to cut the appliance, a siren, and a speaker.

Recipes that can use it

These recipes are built around other hardware, and pick this device up as an optional extra.

Energy · v1.0.0

Solar Surplus EV Charging

Installs a Home Assistant automation that starts your EV charger when your solar array is producing a surplus and stops it when production drops, so the car pulls from the roof rather than the grid. Add a grid meter and a home battery and it holds back until they are happy too.

Type to search across

↑↓ navigate ↵ open
⌘K search